camera will turn on , red light at the back stays on.

"The red light is the Low Battery indicator.

When replacing batteries, use only new, fresh, premium quality alkaline batteries. Regular cheap flashlight batteries are not suitable.Batteries have limited shelf life. Check that the batteries are not past their use-by date.Beware of counterfeit batteries. These look just like premium quality batteries from well known brands but have inferior performance. They are often sold at convenience stores, sometimes at suspiciously low prices.If you are positively sure the batteries are OK, and the camera still won't work, check the contacts in the battery compartment for corrosion. Clean if necessary.If all else fails, have the camera checked. The camera may have developed a problem that causes excessive power consumption, thereby loading the batteries down."

Me too!! It’s happened when my film stuck in the camera bcs the battery died suddenly. Have u solve ur problem?

If you look inside of the battery chamber, it says to either use LR6 batteries, or 1.5 Volt batteries. I hope I helped

Thanks for this answer! It turns out that i wasnt paying attention to the batteries i were grabbing from the container, and mustve grabbed dead ones when i was trying to replace them lol. That probably doesnt make sense, but if i hadnt looked up what the solid red light meant, i woulnt have replaced them. Thanks again

mine stays red but my batteries arent dead. i dropped them on the floor and they are fine. Maybe something else???