Enable remote management on the Zyxel NBG-460N through the telnet utility

Enable remote management on the Zyxel NBG-460N through the telnet utility I was going through the remote management settings on my Zyxel NBG-460N router, making sure they were not available through the WAN port, when I stupidly without thinking disabled the WWW remote management. I can still login through telnet utility, but cannot find any documentation for that for the NBG-460N.
Asked by: Guest \| Views: 129

Total answers/comments: 1

Comments display order:

Guest [Entry]

"The OP stated these commands worked:

sys server load
sys server access http 0
sys server save

sys server disp

The load and save commands should enclose any access command.

Other formats for this command (based on the CLI version)

sys server access [ftp|telnet|web] [access type]

Set the server access type to be 0: ALL, 1: None, 2:LAN only, 3:WAN only

sys server access web 0

Also,

sys server access [telnet|ftp|ssh|http|https|icmp|snmp|dns]
[lan|wan1|wan2|dmz|wlan] [on|off]

sys server access http lan on

Using sys server disp initially may give you a clue what the command should look like. Refer to the CLI guides here and here."