Home » Questions » Computers [ Ask a new question ]

Stops at spin cycle with UL

Stops at spin cycle with UL

what do i need to fix if it stops on spin cycle with UL. its spins in one direction for couple seconds then stops n starts to spin in opposite direction...it does this back n forth over and over but never goes into spin cycle

Asked by: Guest | Views: 213
Total answers/comments: 1
Guest [Entry]

"@benlogali9 the UL code is for Unbalanced Load

uL is displayed when the machine/motor control detects an off-balance load, and is steady on while the washer runs a mini-cycle to rebalance the load.

• Display clears if mini-cycle successfully rebalanced the load.

• If the mini-cycle is unsuccessful, uL will flash until the door lid is opened, allowing the customer to view and redistribute the load.

There are a few things that can cause this. Check the suspension kit of the drum to make sure that it is not excessively loose. Most commonly for this model is a failed rotor position sensor or a cracked stator on the motor. To check that, you will have to check the bottom on your washer. Make sure that the motor bolt is tight

The following images show how to get to those two parts.

You do want to consider posting some images with your question. Use this guide Adding images to an existing question for that. It will allow us to see what you see."