Home » Questions » Computers [ Ask a new question ]

Turn the power off and on again message

Turn the power off and on again message

When i turn on the camera, the lens focusing two or three times open and close, then the message comes "TURN THE POWER OFF AND ON AGAIN" in the display.

Asked by: Guest | Views: 287
Total answers/comments: 6
Guest [Entry]

"balaji, this message most commonly appears when the lens does not fully retract or opens.

""Lens won't fully extend ¶

Screen shows Turn off and on again. ¶

Turn off the camera, remove the batteries from the camera and wait a few minutes. Replace the batteries and turn the camera on.

If the lens will still not extend, replace the batteries and turn the camera on.

If the lens will still not extend, check to see if there is any particles in the lens barrel. Blow air in the lens barrel to remove any sand or grit that may be preventing the lens from extending completely."" I've had some good result by using a vacuum cleaner to assist the lend to extend and to clean it out. There is also more generic information about that on here. You will find a decent video (not exactly your model, but same problem), on youtube Hope this helps, good luck."
Guest [Entry]

"1. Throw the camera on a carpeted floor.

2. Blow on the lens.

3. Switch on the camera.

This is what I did when it said ""Turn the power off and on again."" It works fine now"
Guest [Entry]

I had this issue and I managed to find a primitive fix, see my comment here.
Guest [Entry]

What! No f'ing way! I threw it on my couch boom! Battery pops out. I pop it back in, turn it on! Done! Fyi. I have a very soft couch!
Guest [Entry]

Turn the power off and on agin problem
Guest [Entry]

Try to force rotate counterclockwise the back lens to force open it