I am trying to change the battery on a SkyCaddie?

"I used a screwdriver and pried it open - slowly jimmied it all the way around. It did make small marks on both the front and back panel where I pried...but I sanded them off.

My battery was fixed to the back panel by double sided, black tape. It was a delicate procedure getting it off without breaking the back panel. After I figured out it was tape, I used my regular screwdriver and slid under the tape.

Unplugs very easily and snapped back together.

Just tried it again to make sure I did not break anything before writing this to you. It is good to go.

Also, the screws take a T6 torque bit fitting. You will run the risk of stripping the heads if you use a Phillips screwdriver.

Hope this helped."

"There are eight mini screws to remove back cover of Skycaddie watch.

I bought a replacement battery 3.7v, 250mah and repalce the battery.

Please note that you need to get a service to replace the comnector ro your new battery.

If anyone would like to buy the above battery, please drop a not to dick.lee@bcs-consult.com and i will provide more information."

I have the Izzo 3000 golf gps, it has screws on the back which came out fine. The battery was soldered in, using a solder iron I took it out and then soldered in the now battery I purchased from eBay. As for your Sky Caddie, I'm sure a sharp blade of some kind can be wedged into it somewhere making it pop open. Have you checked You-Tube for a video that might show you how, good luck.