Gets stuck filling and spinning
Kenmore 600 washer when you set timer to 9 or below it works fine but when you set to above 9 it will fill rinse and then gets stuck where its draining and filling at the same time
ANSWERS:
"If the washer is filling and draining water at the same time check the following:
Make sure that the house drain is at least 30 inches high. If so, check to make sure the drain hose is not pushed too far down into the drain. If it is, pull it out 2"" inches. That should solve the problem.If house drain is not at least 30"" high, an anti-siphon clip was included in the installation package. It attaches to the hose and the back of the washer to lift the drain hose up. For more information, see Washer Drain Height.View a short video on washer filling and draining:https://products.geappliances.com/applia..."
|