Home » Articles » Business

Factors that can Influence the Efficiency of Spiral Separator

Many factors can influence the effect of classifier, spiral separator process, including basic structure, the nature of the ore and the operating conditions. As for the aspect of structure, the size of the tank grading area is the decisive factor affecting the amount of processing and grading granularity in the grading machine.

Increase the width of the groove, increase the height of the overflow weir, or decrease the inclination angle, can increase the classification area.

Grading slot width depends on the screw diameter (ie grading machine specifications), and the width should be 100 to 200 mm larger than the diameter.

Inclination of the bottom of the main determinant is decided by the necessary lifting height of sand return water, and the limit is no over slipping of the ore.

During the operation, the changeable structural parameters is mainly the height of the over flow weir, but it is rarely changed once decided at the beginning of production.

The height of over flow weir normally refers to the declining height between the center of spiral bearings and the top of over flow weir.

For the high weir classifier, the height is 400 to 800 nun, but for the submerged classifier, the height is 930 to 2000 nun.

The rotational speed of the spiral plates directly influences the degree of agitation of the liquid surface and the ability to transport the sand back.

The number of revolutions is related with the helix diameter, which is in the range of 1.5-10 r / min.

The influence of the nature of the ore on classification mainly shows in the ore density, grain size and clay content.

Ore density is almost proportional to the impact on the production capacity of the grading machine by weight; the influence of feed size composition and clay content is mainly reflected in the slurry viscosity.

Viscosity increased and mineral particles settling velocity decreases, the processing power and the accuracy of classification would all be reduced.

Therefore, during the feeding process, if the mud is too much, pre-desliming is needed. But in thr feeder of mechanical classifier, there is no harm to contain some mud in the ore, on the contrary, sometimes, it is beneficial.

For the classification of ore with much mud and fine ore, operation under low density is good for the improvement of the classifying efficiency.  http://impactcrusherhongxing.blog.com/
- https://www.affordablecebu.com/
 

Please support us in writing articles like this by sharing this post

Share this post to your Facebook, Twitter, Blog, or any social media site. In this way, we will be motivated to write articles you like.

--- NOTICE ---
If you want to use this article or any of the content of this website, please credit our website (www.affordablecebu.com) and mention the source link (URL) of the content, images, videos or other media of our website.

"Factors that can Influence the Efficiency of Spiral Separator" was written by Mary under the Business category. It has been read 1607 times and generated 0 comments. The article was created on and updated on 19 September 2012.
Total comments : 0