My wand won't release. How can I get it out?

"I don't own this, but my research found this:

Twist The Telescoping Wand

Step 1

Grip the end of the telescoping wand where it meets the hose with one hand. Press in on the release button that is on the end of the hose with the other hand.

Step 2

Twist the end of the telescoping wand clockwise and then counter-clockwise while keeping the button depressed.

Step 3

Pull the wand off the hose while twisting it. Release the button once the wand is free of the hose.

Lubricate The Telescoping Wand

Step 1

Place a sheet of newspaper on the floor or carpet. Collapse the telescoping wand. Hold the hose so that the wand is facing down, over the newspaper.

Step 2

Place an end of the included plastic straw in the nozzle at the end of the lubricating spray can. Shake the can for five seconds.

Step 3

Spray a sustained burst of lubricating spray around the seam where the end of the wand and the hose meet. Remove the can once you have circled the seam.

Step 4

Keep the hose pointed down for two minutes and then grip the end of the wand with the other hand.

Step 5

Twist the end of the wand clockwise with one hand while twisting the end of the hose counter-clockwise with the other. Continue twisting until the wand comes free of the hose. Wipe both ends off with a paper towel. Throw the newspaper in the trash.

Pull The Telescoping Wand

Step 1

Unplug the vacuum cleaner's power cord from the wall outlet. Twist the section of the hose connected to the socket on the vacuum counter-clockwise to remove it.

Step 2

Collapse the telescoping wand, followed by collapsing the hose. Hold the two horizontally with the open end of the hose facing left and the wand facing right.

Step 3

Press the release button at the end of the hose next to where the wand is, providing there is one, with your left hand. Hold the hose steady while twisting the end of the wand away from you with the other hand.

Step 4

Continue to twist the wand while pulling it toward your right. Stop twisting the wand once it comes off the end of the hose.

Step 5

Release the hose button, if there is one. Return the hose to the socket on the vacuum cleaner.

SOURCE: https://www.hunker.com/13409428/the-tele..."

There are two types of wand release. The upper and the lower part of the wand. The lower one has a release right behind the handle of the wand. It has wand release written right on top of the button. If there’s nothing broken beyond this button it should come right off. The upper wand release is in front are the vacuum right below the handle. Press the button and lift the top handle out where it’s very easy.

"That is not a wand release. The only wand release is the button marked as such.

The other button you mention is simply to release the very top piece, the wand will still be in the vacuum.

I assume you have unwound the cord and that isn’t your problem?

The next thing to do is to grasp the chrome part of the wand, hold onto the main part of the vacuum and try to twist it slightly.If you have someone else to hold it, so much the better. If it isn’t the cord, in my experience, it is just ever so slightly out of wack where it connects on the bottom. Try twisting one way, then the other and try the release button again."

I have same problem and looks like there is no solution!!

Unwind the cord first, then pull the wand.