case on the back of the screen is unglued

"Brady Cabe



Rep: 2.7k




33


16


4"

I note the procedure for removing the LCD involves heating the glue seam with a heat gun. It is possible that you could gently heat the affected area with a heat gun and with luck the glue soften and stick again. I would caution you this is just a theory--I don't know if it would work and you would need to be very careful not to cause further damage. Ralph

"I had exactly the same problem. Thanks to this thread and similar ones around the web, I managed to fix it and it seems like it will hold. What I did was follow the these steps:

1) Shut the computer down completely and close the lid.

2) Lie it flat and carefully scrape away old glue on the exposed hinges.

3) Mix a full-strength two-part epoxy (it's stronger than super-glue).

4) Use a toothpick to carefully apply this to the exposed hinges.

5) Press the closed lid into it's correct place and wipe away any excess epoxy.

6) Using a cloth, two thin pieces of wood, and a loose wood clamp (or a heavy book) keep it pressed into position until the epoxy fully sets (up to eight hours). Make sure, of course, the clamp is only tight enough to hold it in place and no tighter.

A day later and it looks as good as new. I've seen elsewhere that you could just use super-glue and holding it together for 10 minutes, but this fix above seems more permanent."

i just glued it with an apoxi resin made for aluminium... seems to be fixed so hopefully it will hold! thanks for your time

"Hi All,

I've had exactly the same problem as outlined above, however my casing lifted on the right hand side and then 1 week or so later lifted on the left (basically exposing the whole back side of the computer so that I can see in under the case at the back and can see the reverse side of the screen). The laptop had never been dropped, always travelled in padded case and was (is) treated with love n respect...

I found yr fix and applied 2 part epoxy resin and clamped for 10 hours (or so - just to be sure... the only time the machine has not received love). It stayed solid for about a month and then lifted again on the weekend.

Has anyone else had both corners lift? Has everyone else found the fix to hold (beyond a month)? And does anyone have any suggestions??"