How can I address the F1 error code?

How can I address the F1 error code? My Cabrio washing machine constantly stops during the wash cycle and shows an F1 error code. I hit pause and start at least 50 times over two hours to complete my wash. Is there a part I can replace so that my wash cycle operates properly?
Asked by: Guest \| Views: 235

Total answers/comments: 3

Comments display order:

Guest [Entry]

"Common, Water Pump. ( Clogged or Broken )

to get door to open, use wet-dry vacume to pull water out from washer, by vacumming water out from drain hose. ( the tube that goes to the hole in your wall. =-D)

Soap dispenser Missing Magnet sensor, or soap dispenser is not all the way in.

Motor control Unit is bad, or door lock solenoid is damaged."

Guest [Entry]

I had the same issue. I replaced the board and the F1 error was still there. I decided to put a hose clamp on the hose coming from the board. Boom my F1 error is gone. Hope this helps.

Guest [Entry]

A friend of mine had the same issue F1 code. We tried to unplug for 10 minutes and plugged it in about 6 or 7 times. We checked the breaker box a couple times, didn't realize one side of the double breaker was f##@ed. Changed out the breaker. No problems.