Canon Printer MG6350 doesn't print support code 6000?

I noticed that when I turned on the device, the ink cartridge holder was on far left and it wasn't moving like it was suppose to. It was stuck. So I pushed it over a littler on left, turned on device and that seemed to work.

"short version: fixed this by finding paper jammed in 2 separate places.

long version: Had 6000 and then 6001 error on MG7751. Paper had been repeatedly jamming at back of paper tray. First solution was to remove paper tray and then turn over printer on its side to find jammed paper underneath at rear. But that wasn't enough and I still had the 6000 and then 6001 error. Going deeper I found that I could remove the panel at the rear of the printer AND another curved component just behind that. This revealed another jammed sheet which was easy to remove. The two printer pieces were easy to put back in place. Then I had to restart the printer, after which it did that Canon thing of clicking a whirring for a few minutes before finally printing again."

"Okay, I had the Similar Issue With My Printer Today So i did Some digging Online & After talking to Canon Support & Hours Of Time Spend Here is Something You Can Try that may solve the issue

Reboot the Printer Using the Power Key. Press the Power Key & Hold it for 20-30 seconds While the Printer is Plugged to power Supply.Open the Printer Cover Clean the Dust, Small Pieces of Paper & Unseen Tiny Objects Stuck to paper feedRemove any obstacles Blocking the Printer Paper Feed & check to insure the paper feed try is Set Properly.

to Know More Visit How to Fix Canon Error 6000 Support Code Problem.

Please let me know if this Helps you Address the Issue."

"Do following:

Verify that your printer tray is properly set.Remove the object they they are placed in front of printer.Clean if there is any piece of paper or something else in printer.Clean the encoder strip with soft cloth.

I hope with these points your issue might be resolved if not then check Canon Pixma Mg6350 Manual to troubleshoot your printer."

"Had Service Error 6000 on my MG5750. The ink cartridges would just stay on the far left of the printer. I moved them to right side of the printer and saw some paper stuck in some white cogs on the far left of the printer ( quite hard to see, I had to stand the printer up on its side). After that I restarted and no more error code, working fine now.

Hope this helps!!!"